本指南有最近更改，您可查看未经巡查的最新版本。
简介
如果你的iPhone 14 屏幕破裂，对触摸没有反应，或在手机开机时不显示图片，请使用本指南更换新屏幕来拯救你的iPhone。
本指南使用的是A2882（国际通用型）型号。 如果你修复的是不同的 iPhone 14 型号，你的手机可能看起来会有些不同，但过程应该是相同的。
注意： 原彩显示和自动亮度调节功能在更换屏幕后将被禁用，即使你更换的是原装 Apple 屏幕也是如此。 除非 iPhone 运行 iOS 15.2 或更高版本，否则面容 ID 也会被禁用。
在重新组装设备时，你需要更换粘合剂来重新连接电池和屏幕。你的设备将正常运行，但很可能会失去外壳IP（侵入保护）防护。
你所需要的
-
-
从尖端测量 3 毫米，并用永久性记号笔标记三角撬片。
Got to step 2 and realized the fix kit doesn't include an opening pick! Looks like a guitar pick, and I have those lying around. Is that expected? Looks like the pick is used in many steps below. There's a little blue crowbar that isn't mentioned in the instructions. Perhaps that replaces the opening pick?
Hi! I can't see which guide you were using when writing this comment. Can you reply here with which guide and fix kit you used?
I see you posted this in Meta. I hope it's resolved soon! In the meantime, a guitar pick may work well enough for your repair.
what fix kit?
My fix kit didn't include an opening pick either
My AliExpress refurbished screen came with a pick that has a coin-like circle that pops out, so no modification was necessary
It's not an Ifixit KIT if it doesn't include everything. You'll need to order the opening pic separately. Or head to Walmart like myself and look for guitar pics. Hopefully, this will work just as well.
No pick in mine as well. It’s really not clear that you have to order this separately when ordering an IPhone SE 202/2022 screen repair kit. Is this the case?
Frustrated, I ordered a compact package where everything was encapsulated. Useless suction tools could not separate the screen. If it is unable to decouple the screen, then why sucking suction tools you have provided.
For my kit the triangle pick was stuck inside the box with the screen not with the other tools maybe it's also there for you
Y’all are getting far, FAR too detailed with some of this stuff…. Measuring and marking the pick that you won’t actually use to open the device?!? lol that’s kinda funny. Just heat it up, grab a spudger, and the back just pops right off! The iFixit tech need to stick to the KISS method more often, you know KEEP IT SIMPLE STUPID!!! Like l, for reals, I’ve been doing this stuff for YEARS and using iFixit guides regularly and this is just ridiculous at this point!
Will the phone still work if the sensor assembly on the back of the screen is damaged?
-
-
-
将重叠的透明包装胶带条黏在 iPhone 的后玻璃上，直到覆盖整个手机后部。
-
如果在接下来的几个步骤中无法让吸盘粘在手机上，请将强力胶带（折叠到把手中，然后用它提起后玻璃。
Had to do the superglue. Also that glass was so shattered that it came off in pieces, took my almost an hour to get the whole screen of. Tape didn't really help there, it would just pull the tape off instead of the screen. Do note that the whole screen assembly is quite thick, I think I initially put my pick in a layer inbetween.
1st step you have forgotten remove the back to disconnect battery golden rule battery first
-
-
-
参照本指南了解如何使用附带的胶带固定屏幕。
-
将蓝色手柄拉向铰链以解锁反向钳的手臂。
-
将反向钳手臂滑过 iPhone 的左边缘或右边缘。
-
将吸盘放在靠近 iPhone 底部边缘的位置——一个在正面，一个在背面。
-
向下推吸盘以将吸力施加到所需区域。
-
-
-
-
在 iPhone 的左下角插入第二个三角撬片。
-
同时扭动两个撬片，直到左侧的卡扣松开。
My glass was so shattered that twisting picks never was going to create enough force for the centre to come loose. I just pulled up the corners with my hands.
-
-
-
使用撬棒的尖端将接口从其插座中垂直向上撬开，从而断开屏幕排线。
@robialecm It's not necessary, although it is a bit risky to do it without disconnecting the battery by just turning it off. Anyway, I wanted to check if the new screen was working before fully reassembling, otherwise the warranty on my replacement screen would be void. I have to admit I accidentally turned on the phone a few times, it's hard to not press the power button every once in a while. I managed to turn off the phone more or less by pressing volume up then volume down then hold power button then wait until reboot, keep holding power button until screen goes dark, then quickly release. But I was lucky that the new screen didn't sustain any damage because I'm pretty sure the phone was on while I was messing with the display connector.
I was very careful reconnecting the cables, and therefore it took my a very long time. Every time I pushed one side, the other side would come out. In the end the trick was to keep one side pressed down while gently - not too gently - pressing the other side.
-
请在重新密封手机前将手机开机并测试你的维修是否成功。
若要重新组装你的设备，请按倒序执行这些说明。
固定新屏幕的最好方法是在框架上贴一张定制的双面胶，然后将屏幕放回原来的位置。
请将你的电子垃圾送到R2或e- steward认证的回收商。
请在重新密封手机前将手机开机并测试你的维修是否成功。
若要重新组装你的设备，请按倒序执行这些说明。
固定新屏幕的最好方法是在框架上贴一张定制的双面胶，然后将屏幕放回原来的位置。
请将你的电子垃圾送到R2或e- steward认证的回收商。
25等其他人完成本指南。
团队
Tobias Isakeit - Repairability Engineer Tobias Isakeit - Repairability Engineer 的会员
Business
1 名成员
创作了1,131篇指南
8条评论
great and good job
What about the battery isnt it a risk to connect it like this. Feels like half of the repair job,
Hi atlas Tanko, you're right, normally we recommend disconnecting the battery before replacing the screen. Due to the design of the iPhone 14 and 14 Plus (separate entry methods for screen and battery replacements), we consider it safe in this case. For the iPhone 14 Pro and Pro Max, we still include steps for disconnecting the battery during screen replacements.
Hi
iPhone 14 not showing display after replacement.
Connected old one, still no display.
I have previously discharged battery down, managed to access torch and also let screen on up to 10m at time - even though screen was quite damaged.
I am a 'careful repairer', but of course one can easily short pins of screen connector while trying to fit it, even though I use magnified glasses to see I do it as best as possible.
Any idea, do not know the 14 at all.
Thanks
Hi JoeBlog,
Sorry to hear that you're facing some issues with your repair. How long did you let your phone charge after the repair? Did the device show signs of turning on, like vibration while booting / doing a hard reboot? Does it get recognized when being plugged into a computer? Please also check our troubleshooting resources for the iPhone 14.
you don't disconnect the battery ?
Always disconnect the Battery!
Oliver -
PLEASE remove back first and disconnect battery before taking cables off!! as per Apple instructions
PC Technology Group - 回复