/
我的工作台

快速访问设备的指南、配件和论坛

DE
Deutsch
ES
Español
IT
Italiano
PT
Português
TR
Türkçe
JP
日本語
EN
English
FR
Français
NL
Nederlands
RU
Pусский
ZH
中文
KO
한국어
注册
登录

Reemplazo de la placa lógica del iPad Air LTE

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的2指南。

返回指南
英语
西班牙语
上一步 下一步

正翻译步骤 31

步骤 31
iPad Air LTE Logic Board Replacement: 步骤 0 中的图像 1，3 iPad Air LTE Logic Board Replacement: 步骤 0 中的图像 2，3 iPad Air LTE Logic Board Replacement: 步骤 0 中的图像 3，3

  • Remove the battery isolation pick.

  • Insert a plastic card underneath the logic board at the battery connector.

  • Do not use excessive force when inserting this card under the logic board to prevent damaging its battery pins. If the logic board wont budge easily, try reheating the adhesive underneath with an iOpener.

  • As you push through the adhesive at the outer edge of the logic board, be careful not to damage the upper button assembly ribbon cable that you disconnected in Step 60. Position the card exactly as shown.

  • Slide the card all the way underneath the logic board, separating the adhesive along the outer edge.

Retira la púa de aislamiento de la batería.

Inserta una tarjeta de plástico debajo de la placa lógica en el conector de la batería.

No utilices demasiada fuerza al insertar esta tarjeta bajo la placa lógica para evitar dañar las patillas de la batería. Si la placa lógica no se mueve con facilidad, intenta recalentar el adhesivo de debajo con un iOpener.

Al empujar a través del adhesivo en el borde exterior de la tarjeta lógica, ten cuidado de no dañar el cable plano del conjunto de botones superior que desconectó en Paso 60. Coloca la tarjeta exactamente como se muestra.

Desliza la tarjeta hasta el fondo por debajo de la placa lógica, separando el adhesivo a lo largo del borde exterior.

[* black] Remove the battery isolation pick.
-[* black] Insert a plastic card underneath the logic board at the battery connector.
+[* black] Insert a [product|IF145-101|plastic card] underneath the logic board at the battery connector.
[* icon_caution] Do not use excessive force when inserting this card under the logic board to prevent damaging its battery pins. If the logic board wont budge easily, try reheating the adhesive underneath with an iOpener.
[* icon_caution] As you push through the adhesive at the outer edge of the logic board, be careful not to damage the upper button assembly ribbon cable that you disconnected in [guide|63740|Step 60|stepid=134002]. Position the card exactly as shown.
[* black] Slide the card all the way underneath the logic board, separating the adhesive along the outer edge.

您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。