Skip to main content

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的79指南

英语
中文

正翻译步骤 1

Step 1
Before proceeding, power down your MacBook. Close the display and lay it on a soft surface, top-side down.
  • Before proceeding, power down your MacBook. Close the display and lay it on a soft surface, top-side down.

  • Use a P5 Pentalobe driver to remove ten screws securing the lower case, of the following lengths:

  • Two 9 mm screws

  • Eight 2.6 mm screws

在开始更换之前,关机,合上显示器然后把机器正面朝上平放在软面上。

用螺丝刀拧下下面的十个螺钉:

两个9mm 梅花头螺钉

八个2.6mm梅花头螺钉

所需的螺丝刀在这里有售

[* icon_note] Before proceeding, power down your machineMacBook. Close the display and lay it on a soft surfacesurface, top-side down.
[* black] RemoveUse a [product|IF145-090|P5 Pentalobe] driver to remove ten screws securing the lower case, of the following ten screwslengths:
[* red] Two 9 mm P5 Pentalobe screws
[* orange] Eight 2.6 mm P5 Pentalobe screws
[* black] The special screwdriver needed to remove the ten 5-point Pentalobe
screws can be found [product|IF145-090|here].
[* icon_note] Before proceeding, power down your machineMacBook. Close the display and lay it on a soft surfacesurface, top-side down.
[* black] RemoveUse a [product|IF145-090|P5 Pentalobe] driver to remove ten screws securing the lower case, of the following ten screwslengths:
[* red] Two 9 mm P5 Pentalobe screws
[* orange] Eight 2.6 mm P5 Pentalobe screws
[* black] The special screwdriver needed to remove the ten 5-point Pentalobe
screws can be found [product|IF145-090|here].

在开源创作共享许可协议下,你的投稿已被许可