• 在开始更换之前,关机,合上显示器然后把机器正面朝上平放在软面上。

  • 用螺丝刀拧下下面的十个螺钉:

    • 两个9mm 梅花头螺钉

    • 八个2.6mm梅花头螺钉

  • 所需的螺丝刀在这里有售

These pentalobe screw sizes can't possibly be right - not even close. Should they perhaps be 0,8 mm and 1,2 mm?

Rulle Boer - 回复

The screw sizes refer to the length of the shaft, not the diameter of the head or socket. P5 is the standard pentalobe size for all these screws, regardless of length.

I agree that the notation is a little confusing. I think it's because, with standard sized hardware like for your house, you have shaft diameter (say 1/8" or 3mm) and shaft length (say 3" or 7.5cm). So we're programmed to think of small numbers like that as diameter. But in this case, they're length.

budpegasus - 回复

Pulling the fan cable out was terrifying but you actually just pull on the cable itself. No way to get any leverage at the connector to dislodge it. Did come out easily but like I said, scared me!

allison - 回复

Draai de schroefjes voorzichtig los en leg ze op een stabiele plek neer en let erop dat de schroefje een verschillende lengte hebben.

bwgvanderveer - 回复

I thought I could replace my 256 Gb SSD with 512? regards

ola m - 回复

Do you have good Test Point Voltages? It appears there are silver colored Test points on the I/O Board. I am working on a water spill and trying to troubleshoot if both the I/O board and the Logic need replaced.

andrew - 回复

It's probably not necessary but may be a little safer to completely discharge the old battery before replacing it.

Larry Smith - 回复

tell a model that was not inferior to the speed of the one in the laptop.

Thank you

ilyabuhov - 回复

Do i need to order tools separately to replace the battery i just ordered?

anne uhlir - 回复

im looking for a Logic Board for a

Apple - MacBook Air® - 13.3" Display - Intel Core i5 - 8GB Memory - 128GB Flash Storage (Latest Model) - Silver Model: MQD32LL/A

Any help is appreciated.

Jamie Comstock - 回复

把手指插进显示器和底壳之间的缝隙然后向上拉,拆下底壳。
  • 把手指插进显示器和底壳之间的缝隙然后向上拉,拆下底壳。

  • 小心地取下底壳并放在安全的地方。

There is a nub on the inside of the case which is attached to the battery. When you try to pull it open, it appears to be attached to the plastic casing of the battery, which sometimes splits. I gently unhooked the nub from the battery before removing the case fully. This seems to happen if the battery has suffered some drop damage (plastic parts broken around screws and parts of plastic frame split). Just an FYI in case your lower case doesn't pull away easily.

Jeannie Crowley - 回复

When closing this back up make sure that the antenna cable is tucked away neatly

Gabriel - 回复

终点

12等其他人完成本指南。

特别感谢这些译者︰

100%

这些翻译人员帮助我们修复这个世界! 想要作出贡献?
开始翻译 ›

添加评论

浏览统计数据:

过去的24小时: 5

过去的7天: 20

过去的30天: 65

总计 10,840