注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南。
正翻译步骤 14
步骤 14
-
Use scissors to cut one of your opening picks to about the width of the battery. Try not to leave any sharp corners.
-
Insert the modified pick between the right side of the battery and the case.
-
Use constant, steady pressure to slowly pry the battery up, separating it from the adhesive securing it to the system board.
-
On the larger (42 mm) models, it's possible to accidentally pry at the system board underneath the battery. Insert the pick only far enough to get underneath the battery, not the system board.
-
If needed, apply a little high concentration isopropyl alcohol (90% or greater) around and under the battery to help weaken the adhesive.
您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。