跳转到主内容

iPhone 6 Plus Vervanging van de batterij

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南

英语
荷兰语

正翻译步骤 4

步骤 4
iPhone 6 Plus Battery Replacement: 步骤 0 中的图像 1,3 iPhone 6 Plus Battery Replacement: 步骤 0 中的图像 2,3 iPhone 6 Plus Battery Replacement: 步骤 0 中的图像 3,3
  • Peel back the final battery adhesive tab from the bottom edge of the battery. Gently pull the battery adhesive tab upward and away from the battery, allowing the adhesive strip to slowly slide out from between the battery and the rear case.

  • Place one hand over the battery as the final strip comes out, or it may fling the battery out of the iPhone.

  • Continue pulling until the final strip comes free from the iPhone.

  • If you removed all three adhesive strips successfully, continue to step 24. Otherwise, if the adhesive breaks off underneath the battery and can't be retrieved, apply a few drops of high concentration (over 90%) isopropyl alcohol under the edge of the battery in the area of the broken adhesive strip(s).

  • Wait about one minute for the alcohol solution to weaken the adhesive. Use the flat end of a spudger to gently lift the battery.

  • Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

  • Do not pry against the logic board, or you may permanently damage your iPhone. Do not pry under the topmost section of the battery, near the volume up button and mute switch, or you may damage the audio controls cable, which is adhered to the rear case just beneath the battery.

  • For alternative methods to unstick the battery, continue with the next step below.

Trek ook de laatste kleefstrip, aan de onderkant van de batterij, los. Trek de kleefstrip voorzichtig naar boven en weg van de batterij, zodat deze los kan komen uit de ruimte tussen de batterij en de achterste behuizing.

Plaats een hand op de batterij bij het losmaken van de laatste kleefstrip, aangezien de batterij er anders uit kan vliegen.

Blijf trekken tot de laatste kleefstrip loskomt uit de iPhone.

Als je alle drie de kleefstrips succesvol hebt weten te verwijderen, ga je verder met stap 24. Als een van de kleefstrips onder de batterij afbreekt en niet meer kan worden vastgepakt, dien je wat druppels isopropylalcohol (>90%) onder de rand van de batterij toe.

Geef de alcohol een minuutje de tijd om in de lijm te trekken en deze te verzwakken. Gebruik het platte einde van een spudger om de batterij met beleid en rustig omhoog te wrikken.

Probeer de batterij er niet met botte kracht uit te wrikken. Als de batterij niet omhoog wil komen, dien je wat extra druppels isopropylalcohol toe om de lijm verder te verzwakken. Probeer te voorkomen dat je de batterij doorboort of verbuigt.

Wrik nooit tegen het logic board aan om permanente schade aan je toestel te voorkomen. Wrik ook niet onder het bovenste deel van de batterij, in de buurt van de volume omhoogknop en de stil-/luidschakelaar. Als je dit wel doet, riskeer je de volumeknopkabel, die net onder de batterij aan de achterste behuizing bevestigd is, te beschadigen.

Ga verder met de volgende stap als je een alternatieve methode nodig hebt om de batterij van de lijm eronder los te maken.

您的所有投稿皆享有基于开源创作共享许可协议(CC BY-NC-SA)著作权利