跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的71指南

英语
西班牙语

正翻译步骤 25

步骤 25
Be very careful with this step. Take your time and ensure the adhesive is hot and soft, and that you've been through all of the adhesive with an opening pick. Don't be afraid to stop and reheat. On the side of the iPad opposite the volume controls, you should have a pick lodged into each corner. Twist the picks to lift the glass slightly, separating the last of the adhesive along the display cable edge.
  • Be very careful with this step. Take your time and ensure the adhesive is hot and soft, and that you've been through all of the adhesive with an opening pick. Don't be afraid to stop and reheat.

  • On the side of the iPad opposite the volume controls, you should have a pick lodged into each corner. Twist the picks to lift the glass slightly, separating the last of the adhesive along the display cable edge.

  • If you encounter a significant amount of resistance, leave the picks in place, reheat, and reapply the iOpener to the problem areas.

Ten mucho cuidado con este paso. Tómate tu tiempo y asegúrate de que el adhesivo esté caliente y suave, y que haya pasado por todo el adhesivo con una púa de apertura. No tengas miedo de detenerte y recalentar.

En el lado del iPad opuesto a los controles de volumen, debe tener una púa alojada en cada esquina. Gira las púas para levantar ligeramente el vidrio, separando el último adhesivo a lo largo del borde del cable de la pantalla.

Si encuentras una cantidad significativa de resistencia, deja las púas en su lugar, vuelve a calentar y vuelve a aplicar el iOpener en las áreas problemáticas.

在开源创作共享许可协议下,你的投稿已被许可