翻译步骤＃4 - Constructing a Capacitor Discharge Tool - iFixit

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南。

英语

中文

上一步下一步

正翻译步骤 4

步骤 4

Join the lead leaving the resistor to the stripped end of the wire by twisting the two together.

The wire we are using is quite thick, so we inserted the resistor lead down the center of the conductor portion of the wire and twisted the wire against it as tightly as possible.

Solder the wire to the resistor.

Join the lead leaving the resistor to the stripped end of the wire by twisting the two together.
The wire we are using is quite thick, so we inserted the resistor lead down the center of the conductor portion of the wire and twisted the wire against it as tightly as possible.
Solder the wire to the resistor.
It is essential that enough solder flows through the wire to create a permanent bond between the two pieces.

在开源创作共享许可协议下，你的投稿已被许可。