注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的6指南。
正翻译步骤 3
步骤 3
Insert an opening pick
-
Heat an iOpener and apply it to the same edge of the phone for two minutes.
-
Apply a suction cup to the back of the phone, as close to the center of the right edge as possible (where the adhesive is narrowest).
-
Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame.
-
Insert the point of an opening pick into the gap.
-
If you are having trouble creating a gap, the adhesive isn't weakened enough. Make sure you have heated the edge until just barely too hot to touch try this step again.
-
You can try applying a few drops of high concentration (over 90%) isopropyl alcohol into the seam to help loosen the adhesive.
您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。