跳转到主内容

Reemplazo del panel frontal iPad 4G

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的153指南

英语
西班牙语

正翻译步骤 20

步骤 20
Removing iPad 3 4G Front Panel: 步骤 0 中的图像 1,3 Removing iPad 3 4G Front Panel: 步骤 0 中的图像 2,3 Removing iPad 3 4G Front Panel: 步骤 0 中的图像 3,3
  • Slide the opening pick along the left edge of the iPad, releasing the adhesive as you go. The adhesive is thin here due to the digitizer along the whole left side. Make sure the pick is not too deep (max 1/2 inch) 10 mm to prevent damaging the digitizer.

  • The digitizer cable is located approximately 2" (50 mm) from the bottom of the iPad. Stop sliding the pick when you get ~2.25" (60 mm) from the bottom of the iPad.

Desliza la púa de apertura a lo largo del borde izquierdo del iPad, liberando el adhesivo a medida que avanza. El adhesivo es delgado debido al digitalizador a lo largo de todo el lado izquierdo. Asegúrate de que la púa no esté más de 10 mm dentro para evitar dañar el digitalizador.

El cable del digitalizador se encuentra a aproximadamente 50 mm de la parte inferior del iPad. Deja de deslizar la púa cuando llegue a 60 mm desde la parte inferior del iPad.

您的所有投稿皆享有基于开源创作共享许可协议(CC BY-NC-SA)著作权利