正翻译步骤 3
步骤 3
-
Set the heat gun to "Low" or around 300C (575F), and let it run for a few seconds to reach operating temperature.
-
Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot.
| - | [* black] Set the heat gun to "Low", and let it run for a few seconds to reach operating temperature. |
|---|---|
| + | [* black] Set the heat gun to "Low" or around 300C (575F), and let it run for a few seconds to reach operating temperature. |
| [* black] Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot. | |
| [* icon_note] This will prevent damage to the board caused by localized thermal expansion. |
您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。