跳转到主内容

简介

In this guide I will be showing the process of opening up this guitar to clean the contacts on the pickup selector switch. This process will apply to any guitar with a 3 way pickup toggle switch. This guide does not cover guitars with lever type switches.

  1. Note the position that the selector switch is in when the guitar has intermittent or no signal.
    • Note the position that the selector switch is in when the guitar has intermittent or no signal.

  2. Remove the retaining nut that holds the pickup selector switch to the guitar. Remove the retaining nut that holds the pickup selector switch to the guitar.
    • Remove the retaining nut that holds the pickup selector switch to the guitar.

  3. Place the guitar face-down on a soft and clean surface.
    • Place the guitar face-down on a soft and clean surface.

  4. If the guitar has active pickups, open the battery tray and remove the 9-volt battery. If the guitar has active pickups, open the battery tray and remove the 9-volt battery.
    • If the guitar has active pickups, open the battery tray and remove the 9-volt battery.

  5. Remove the large plastic backing plate. Remove the large plastic backing plate.
    • Remove the large plastic backing plate.

  6. Carefully pull the pickup selector switch out of the body of the guitar. Carefully pull the pickup selector switch out of the body of the guitar.
    • Carefully pull the pickup selector switch out of the body of the guitar.

  7. Switch the pickup selector switch to the side that does not work.
    • Switch the pickup selector switch to the side that does not work.

    • If neither side works, then repeat the next step on each side.

  8. Insert the sandpaper into the switch and proceed to scuff the contacts. Be sure to flip the sandpaper and scuff each side of the contact. Insert the sandpaper into the switch and proceed to scuff the contacts. Be sure to flip the sandpaper and scuff each side of the contact.
    • Insert the sandpaper into the switch and proceed to scuff the contacts. Be sure to flip the sandpaper and scuff each side of the contact.

  9. Insert the switch back into the guitar, ensure that the switch is in the correct orientation.
    • Insert the switch back into the guitar, ensure that the switch is in the correct orientation.

结论

To reassemble your device, follow these instructions in reverse order.

Elias Medeiros

于2021年03月24日注册

177 信誉积分

撰写一个指南

团队

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 19

总计 43