跳转到主内容

修复你的物品

维修的权力

商店

  1. To get to the screws beneath the keyboard you need to take some keys off. You can use either an opening tool or an opening pick. The first picture shows how it should look like with all the necessary keys off (12 in total). The four longer keys from the fingerboard are to be handled from the left side to get them off. The eight smaller keys need to be levered from the bottom up.
    • To get to the screws beneath the keyboard you need to take some keys off. You can use either an opening tool or an opening pick. The first picture shows how it should look like with all the necessary keys off (12 in total).

    • The four longer keys from the fingerboard are to be handled from the left side to get them off.

    • The eight smaller keys need to be levered from the bottom up.

  2. The scissor mechanism of the eight small keys are obstructing the underlying screws. By using again an opening tool or opening pick these can be snapped off easily.
    • The scissor mechanism of the eight small keys are obstructing the underlying screws.

    • By using again an opening tool or opening pick these can be snapped off easily.

    • When reassembling be sure to place them in with the correct side facing upwards.

  3. Loosen those 12 screws with a Phillips #00 screwdriver. Then just pull off the four rotary knobs and the volume knob. Now it is possible to slightly lift the keyboard and set it back.
    • Loosen those 12 screws with a Phillips #00 screwdriver.

    • Then just pull off the four rotary knobs and the volume knob.

    • Now it is possible to slightly lift the keyboard and set it back.

  4. Unlock the flex cables by pushing the two black nibs on both sides of each connector.
    • Unlock the flex cables by pushing the two black nibs on both sides of each connector.

    • Now you can pull the flex cables out and remove the keyboard completely.

  5. Open the display cable connector by using a plastic opening tool to flip the latch upwards. The display is held in place with a mild adhesive. A spudger helps you to get it free. Now you can unplug the cable and take out the whole display.
    • Open the display cable connector by using a plastic opening tool to flip the latch upwards.

    • The display is held in place with a mild adhesive. A spudger helps you to get it free.

    • Now you can unplug the cable and take out the whole display.

结论

To reassemble your device, follow these instructions in reverse order.

Tobias Isakeit

于2014年03月31日注册

82,676 信誉积分

创作了156篇指南

团队

iFixit iFixit 的会员

Community

135 名成员

创作了15,004篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 146