该用户尚未填写个人资料。
问题
If your dishwasher’s dispenser doesn’t open every time or leaves detergent inside. Can I put the pods or tablets in the...
阅读更多问题解答论坛
The sensor is dirty. Clean the sensor by removing the bag, pull the handle back and turn on for 20 seconds. Don’t use it on the floor while running. Replace with a clean bag.
阅读更多The battery is no longer able to hold a charge. You can check the battery life under settings and battery.
阅读更多The problem may not be with the vacuum cleaner. A Hoover uses a 12 amp motor. The plug can not exceed 15 amps. If other appliances are on the same circuit as the vacuum cleaner, it will blow a fuse. Try different plugs.
阅读更多Turn over the floor nozzle. Unlock 3 plastic holders with a coin. This will open the bottom panel. Check for any debris blocking the the air flow inside.
阅读更多You have a clog in the floor nozzle.
阅读更多Remember, the handle must be pulled back for the roller brush to turn on AND the power switch must be set to carpet. The green light should turn on.
阅读更多Remember, the handle must be pulled back for the roller brush to turn on AND the switch must be set to carpet or the 2nd position on the switch. Green light should come on.
阅读更多The red light indicates the brush roller has stopped. Something is caught inside the roller brush. Turn off the vacuum. Remove the object and turn it back on. Green light should turn on. Remember, brush roller needs to be turned on when your vacuuming carpet. If not it will be hard to push.
阅读更多it can take some time for the dishwasher to reach a specific temperature before it starts washing. The cycle you choose, the options to heat and the water temperature going in the dishwasher are all factors.
阅读更多So the washer works fine except doesn’t drain all the water. First take notice of the drain hose. Is the water coming out fast as usual? If not, there could be a partial blockage in the hose or the water pump maybe going out. Also, the water valve maybe leaking water back into the tub.
阅读更多第 1页,共 2 页