简介

This guide provides step-by-step instructions on disassembling the Picstart Plus development programmer.

这个拆解是不是维修指南。 要维修你的的Picstart Plus Development Programmer,请使用我们的服务手册

  1. Remove 4 Phillips screws located on the back side of the holding plate.
    • Remove 4 Phillips screws located on the back side of the holding plate.

    • After the screws are removed, remove the case of the development programmer.

    • Carefully take out the circuit board with component side facing up. Put the case aside.

    添加评论

  2. Disconnect the microcontroller module from the main board using a spudger or a similar tool.
    • Disconnect the microcontroller module from the main board using a spudger or a similar tool.

    • Set the microcontroller module aside.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Flip over the mainboard so that the component side is facing down and remove the small Pan head screws that holds the cover of the IC holder

    • Remove the cover of the IC holder.

    添加评论

    • Remove the IC holder lever along with the small metal plate that covers the lever.

    • Set the lever and the lever cover aside.

    添加评论

    • Congratulations! You have completely dismantled the PICSTART Plus Development Programmer!

    • All the extracted components are shown in the picture.

    添加评论

Brad

于2013年11月17日注册

624 信誉积分

创作了2篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 20

总计 1,463