跳转到主内容
英语
中文

正翻译步骤 1

步骤 1
Remove 4 Phillips screws located on the back side of the holding plate. After the screws are removed, remove the case of the development programmer. Carefully take out the circuit board with component side facing up. Put the case aside.
  • Remove 4 Phillips screws located on the back side of the holding plate.

  • After the screws are removed, remove the case of the development programmer.

  • Carefully take out the circuit board with component side facing up. Put the case aside.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可