/
我的工作台

快速访问设备的指南、配件和论坛

DE
Deutsch
ES
Español
IT
Italiano
PT
Português
TR
Türkçe
JP
日本語
EN
English
FR
Français
NL
Nederlands
RU
Pусский
ZH
中文
KO
한국어
注册
登录

Sustitución de la Placa Lógica del iPod Touch 1ª Generación

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的4指南。

上一步 下一步

正翻译步骤 2

返回指南
英语
西班牙语
步骤 2
iPod Touch 1st Generation Logic Board Replacement: 步骤 0 中的图像 1，3 iPod Touch 1st Generation Logic Board Replacement: 步骤 0 中的图像 2，3 iPod Touch 1st Generation Logic Board Replacement: 步骤 0 中的图像 3，3

  • Use a spudger (or your fingernails) to remove the gold antenna. The antenna bends easily, so make sure not to apply too much pressure. When re-assembling, put the gold antenna in place before inserting the antenna circuit boards.

  • Use the spudger to remove the connector on the left side.

  • Remove the 2.4 mm Phillips screw.

  • Remove the 1.6 mm Philips screw.

Usa un spudger (o tus uñas) para quitar la antena dorada. La antena se dobla fácilmente, así que asegúrate de no aplicar demasiada presión. Al volver a armar, coloca la antena dorada en su lugar antes de insertar las placas de circuito de la antena.

Usa el spudger para quitar el conector del lado izquierdo.

Retira dos tornillos Phillips.

[* black] Use a spudger (or your fingernails) to remove the gold antenna. The antenna bends easily, so make sure not to apply too much pressure. When re-assembling, put the gold antenna in place before inserting the antenna circuit boards.
[* black] Use the spudger to remove the connector on the left side.
-[* red] Remove two Phillips screws.
+[* red] Remove the 2.4 mm Phillips screw.
+[* yellow] Remove the 1.6 mm Philips screw.

您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。