注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的4指南。
正翻译步骤 2
步骤 2
-
Use a spudger (or your fingernails) to remove the gold antenna. The antenna bends easily, so make sure not to apply too much pressure. When re-assembling, put the gold antenna in place before inserting the antenna circuit boards.
-
Use the spudger to remove the connector on the left side.
-
Remove the 2.4 mm Phillips screw.
-
Remove the 1.6 mm Philips screw.
| [* black] Use a spudger (or your fingernails) to remove the gold antenna. The antenna bends easily, so make sure not to apply too much pressure. When re-assembling, put the gold antenna in place before inserting the antenna circuit boards. | |
| [* black] Use the spudger to remove the connector on the left side. | |
| - | [* red] Remove two Phillips screws. |
| + | [* red] Remove the 2.4 mm Phillips screw. |
| + | [* yellow] Remove the 1.6 mm Philips screw. |
您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。