跳转到主内容

iPhone 6 plus 电池更换

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南

英语
中文

正翻译步骤 5

步骤 5
iPhone 6 Plus Battery Replacement, Alternative methods to unstick the battery from the case: 步骤 0 中的图像 1,1
Alternative methods to unstick the battery from the case
  • If the battery remains stuck to the rear case, prepare an iOpener or use a hair dryer to heat the rear case directly behind the battery.

  • Then, use a plastic opening tool to gently lift the battery.

  • Overheating the iPhone may ignite the battery.

  • Alternatively, a piece of dental floss may be used to separate the battery from the rear case. A stronger alternative to dental floss is an unwound guitar string, such as a 0.009 E string from a 12-string set.

  • Thread the floss or string underneath one end of the battery and pull side to side in a sawing motion to separate the adhesive.

翻转iPhone,从左侧插入一张卡片到电池和后盖间隙间。

不要对电池的顶端、音量上键、静音键部位撬拉 ,否则可能损坏隐藏在电池后面黏附在后盖上的音量控制排线。

请勿撬到逻辑主板,否则可能对iPhone造成不可挽回的伤害。

尽可能保持卡片与电池接触面水平避免电池弯折,否则可能损坏电池或者引起电池释放有害化学物质。

轻压卡片使易拉胶从电池背部分离出来。

或者一条牙线可以用来把电池和后机身分离。更好的选择是没有使用过的吉他弦,比如12弦套装中的0.009 E弦。

把牙线或吉他弦放到电池的一端,使用锯东西的移动方式来分离黏胶。

-[* black] Flip the iPhone back over and insert a plastic card between the left side of the battery and the rear case.
- [* icon_caution] Don't pry under the topmost section of the battery, near the volume up button and mute switch, or you may damage the [guide|31183|audio controls cable|stepid=74381|new_window=true], which is adhered to the rear case just beneath the battery.
- [* icon_caution] ***Do not*** pry against the logic board, or you may permanently damage your iPhone.
-[* icon_caution] Be careful to keep the card as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
-[* black] Press the card in farther to break up the adhesive behind the battery.
+[title] Alternative methods to unstick the battery from the case
+[* black] If the battery remains stuck to the rear case, [guide|11677|prepare an iOpener|new_window=true] or use a hair dryer to heat the rear case directly behind the battery.
+ [* black] Then, use a plastic opening tool to gently lift the battery.
+ [* icon_caution] Overheating the iPhone may ignite the battery.
[* icon_note] Alternatively, a piece of dental floss may be used to separate the battery from the rear case. A stronger alternative to dental floss is an unwound guitar string, such as a 0.009 E string from a 12-string set.
-[* black] Thread the floss or string underneath one end of the battery and pull side to side in a sawing motion to separate the adhesive.
+ [* black] Thread the floss or string underneath one end of the battery and pull side to side in a sawing motion to separate the adhesive.

您的所有投稿皆享有基于开源创作共享许可协议(CC BY-NC-SA)著作权利