跳到步骤＃10
由 Dylan Treschl — 编辑
编辑已通过 由 Dylan Treschl
- 之前
- 之后
- 不变
步骤行
| [title] Pull off Read/write Head and Remaining Circuitry | |
| [* black] Now, you can pull on the metal tap, and pull off both the read/write head and some of the ribbon cables. Lift straight up to detach the read/write head. Now, you can remove the bottom neodymium magnet. Pull it straight up, and don't put it near the other magnet! | |
| - | [* black] Now, remove the remaining Phillips PH1 screw on the inner PCB and the three Phillips PH0 screws on the assembly right next to the inner PCB. Pull the whole thing out (you have to remove the sticker strap on the outside of the drive. Pull off to remove the ribbon cables and detach the inner PCB assembly firm the drive.). |
| + | [* black] Now, remove the remaining Phillips PH1 screw on the inner PCB and the three Phillips PH0 screws on the assembly right next to the inner PCB. Pull the whole thing out (you have to remove the sticker strap on the outside of the drive. Pull off to remove the ribbon cables and detach the inner PCB assembly from the drive.). |
| + | [* black] Make sure to be careful at this step. I pulled too hard and shattered the mirror assemble, which is made of very sharp and very thin glass. |
| + | [* black] Use a pair of pliers to remove the plastic bar and the brass/rubber standoff from the aluminum drive body. Pull hard and pull up. |