跳到步骤＃6
由 Manfred Wachtel — 编辑
编辑已通过 由 Manfred Wachtel
- 之前
- 之后
- 不变
步骤行
| [title] Removal of rear metal frame | |
| [* black] The next steps describes the removal of the black metal frame. | |
| - | [* black] Be careful, do not touch the open contacts on the left side (pink)! You will be surprised by a "wake-up" electrical shock even 15 minutes after turning off the camera. The flash- |
| + | [* black] Be careful, do not touch the open contacts on the left side (pink)! You will be surprised by a "wake-up" electrical shock even 15 minutes after turning off the camera. The flash-condenser still holds enough energy! |
| [* black] Start on the right side of the camera. There is a small black plastic clip (yellow) which has to be lifted up a little bit. Slowly and carefully begin to separate the rear metal frame from the camera body. | |
| - | [* black] A critical part is the very slim plastic cover on top (green). The red marker will show you which direction you have to move this sensitive plastic part. |
| + | [* black] A critical part is the very slim plastic cover on top (green). The red marker will show you in which direction you have to move this sensitive plastic part. |