跳到步骤＃3
由 Darryl Beckham — 编辑
编辑已通过 由 Darryl Beckham
- 之前
- 之后
- 不变
步骤行
| - | [* black] Remove the following to expose more screws |
|---|---|
| - | [* yellow] Two black rubbers glued. Pull from underneath to unglue them. |
| - | [* orange] One thin plastic cover glued. Pull from underneath to unglue. |
| - | [* black] After exposing the screws, remove the 3 screws. |
| - | [* yellow] Two "size" Phillips ##__ screws |
| - | [* orange] One "size" Phillips ##__ screws |
| - | [* black] After removing the screws under the black rubbers. |
| - | [* red] Remove the two black end case pieces. |
| + | [* black] Slide *tool* underneath the following components and remove from case to expose more screws. |
| + | [* yellow] Two black rubber feet attached with adhesive. |
| + | [* yellow] Remove two "size" Phillips ##__ screws. |
| + | [* orange] One thin plastic cover attached with adhesive. |
| + | [* orange] Remove one "size" Phillips ##__ screw. |
| + | [* red] Once these screws have been removed, take off end caps. |