跳到步骤＃1
由 Ben Eisenman — 编辑
- 之前
- 之后
- 不变
步骤行
| - | [* black] Use a small iPod opening tool to release the black hinge holding the hard drive ribbon cable. |
|---|---|
| + | [* black] Use a small iPod opening tool to release the black hinge holding the hard drive ribbon cable. The tab will rotate up 90 degrees towards the logic board, releasing the ribbon cable. |
| [* black] Use your forefinger to hold the ribbon cable in place; disconnect the drive from the ribbon cable. | |
| [* icon_note] Make sure the hard drive rubber side bumpers are attached to the drive being installed. Use the hard drive rubber side bumper installation guide to accomplish this task. | |
| [* icon_note] If necessary, the blue foam padding on the hard drive might also need to be transferred to the replacement drive. |