跳到步骤＃10
由 Alexis Soule — 编辑
编辑已通过 由 Kristen Gismondi
- 之前
- 之后
- 不变
步骤行
| [* black] Remove the large wire ribbon located under the screw removed in step seven. | |
| - | [* black] Gently wiggle the ribbon in an upward motion. |
| - | [* black] This should be done by adjusting a pair of needle nose tweezers horizontally in order to grasp a greater surface area. This will increase a safer amount of leverage needed to remove ribbon. |
| + | [* black] Gently wiggle the ribbon in an upward motion by using a pair of needle nose tweezers. Position the tweezers horizontally to grasp a greater surface area. |
| [* icon_note] For easier access, you can push the black part of the camera where the buttons and dials are. Just be sure not to push too hard as it may break the plastic. |