跳到步骤＃9
由 Philip Le Riche — 编辑
编辑已通过 由 Philip Le Riche
- 之前
- 之后
- 不变
步骤行
| [* black] With the lens back plate removed, temporarily replace one of the 4 screws which secured it. It will not be possible to drive it fully home; only tighten it until resistance is felt. | |
| [* black] Lift out the three zoom motor gears and put them aside. | |
| [* black] Lift the lens off the bench and using a small flat screwdriver, gently turn the gear teeth which the last zoom motor gear engaged with until the lens is open approximately half way. | |
| [* black] Now feed the two ribbons protruding through a slot in the barrel back into the lens. | |
| [* black] Resting the lens face-down on the bench, retract it to the closed position by turning the gear teeth in the opposite direction. | |
| - | [* black] |
| + | [* black] Follow the reverse procedure for reassembly. |