跳到步骤＃4
由 Bridgetown Electronics Repair — 编辑
编辑已通过 由 Bridgetown Electronics Repair
- 之前
- 之后
- 不变
步骤行
| + | [* black] If you have any damage to the plastic clips on either the top or bottom half of the housing I suggest just cutting or grinding them down so that they don't catch on anything when you're reassembling the housing. I typically use a surgical scalpel and a dremel for this kind of reshaping. Scalpel is better because it does not heat the plastic. |
|---|---|
| + | [* black] We can't use tape to seal the seam again because it will bunch up and not form an even bond which means that an adhesive like E6000 or anything similar is probably going to be our best bet. Run an even bead around the seam, applying it to the top-half of the housing and making sure that you're not obscuring the LED Indicator. |
| + | [* black] Once your adhesive is applied, press the two halves of the housing back together being mindful of the battery wiring and all flex cables near the seam. A clamp positioned with one side on the top of the housing and the other covering the USB-C Port and/or a rubber band should be applied while the adhesive sets. |
图片1
没有之前的图片
已添加
图片2
没有之前的图片
已添加