跳到步骤＃3
由 BoulderMaker — 编辑
编辑已通过 由 BoulderMaker
- 之前
- 之后
- 不变
步骤行
| + | [title] Remove the Plastic/Rubber Foot |
|---|---|
| + | [* black] There's a recycled plastic and rubber foot affixed to the bottom of the device. This acts as a higher-friction softer foot so as not to scratch surfaces, like wood, and to dampen vibrations. It also covers the re-flash port. This footing is held on by a light seam of adhesive that is easily compromised. |
| + | [* black] Using a controlled heat source, warm the foot to loosen the adhesive. |
| + | [* black] Insert a pick between the foot and device body to pry them apart. If warmed adequately, the foot should be easy to pop off. |
图片1
没有之前的图片
已添加
图片2
没有之前的图片
已添加
图片3
没有之前的图片
已添加