跳到步骤＃5
由 Leo Maxwell — 编辑
编辑已通过 由 Leo Maxwell
- 之前
- 之后
- 不变
步骤行
| + | [title] Join the ends of the belt |
|---|---|
| + | [* black] Use cyanoacrylate glue (superglue) to bond the ends together. Hold the joint in firm compression for at least 90 seconds. ***Allow at least 3 hours before fitting.*** |
| + | [* black] The glue will dissolve the rubber to form a strong but flexible joint. Any excess that is squeezed out of the joint will be brittle, and can be chipped off with a blunt knife. Once set, the joint should be tested by firmly pulling to load the joint in tension. |
图片1
没有之前的图片
已添加