跳到步骤＃14
由 Brooke Mason — 编辑
编辑已通过 由 Brooke Mason
- 之前
- 之后
- 不变
步骤行
| [title] Heat Shrinking | |
| - | [* red] Obtain a section of heat shrink tubing, and slide it onto the section where the pressure transducer wires are now connected to the 32 inch wires. This will be used to stabilize the connection and protect the more fragile silver wire. |
| + | [* red] Obtain a section of heat shrink tubing, and slide it onto the section where the pressure transducer wires are now connected to the 32 inch (or 10 inch) wires. This will be used to stabilize the connection and protect the more fragile silver wire. |
| [* icon_note] It may be a little difficult to get the tubing over all three butt splices and the hydrophobic cap, but it should end up fitting snugly. | |
| [* orange] Heat shrink the material around the connection point, starting from one end and slowing moving around in circles, moving towards the other end until it looks like this. |