跳到步骤＃12
由 Brooke Mason — 编辑
编辑已通过 由 Brooke Mason
- 之前
- 之后
- 不变
步骤行
| [title] Stripping Pressure Transducer Wires | |
| [* red] Use the coax cable cutters to remove about 8 inches of the thick black covering. This will need to be done in about 1 inch sections! | |
| [* icon_caution] Be careful not to break or cut the other wires (the silver wire is especially fragile)! | |
| [* orange] Use pliers to twist/pry off each smaller section of black cable. | |
| - | [* yellow] Next, trim the silver and black wire to the same length(about 4 inches exposed). The red wire should be kept at 8 inches. |
| - | [* green] Use wire strippers to expose the inner silver wire from the black and red wires |
| - | [* icon_note] After each section comes off, the blue wire and plastic can be completely cut away |
| - | [* icon_note] The clear tube can be cut away a little bit to make it easier to pull the sections off, but make sure to leave a couple inches of it |
| + | [* green] Use wire strippers to strip 1/4 inch of the black and red wires |
| + | [* black] The blue wire can be completely cut away. |
| + | [* black] Place the membrane cap onto the clear tube |