跳到步骤＃3
由 Colin Tourjee — 编辑
编辑已通过 由 Colin Tourjee
- 之前
- 之后
- 不变
步骤行
| - | [* black] With the front of the printer facing you, lift and raise the left side of the panel (like opening a book in reverse) until it disconnects from the clip on the right side of the panel. |
|---|---|
| + | [* black] Locate the three screws which hold the circuit board in place. |
| + | [* black] Remove each screw using a screwdriver with the T10 torx bit. |
| + | [* black] Replace the circuit board with a new one. |