Yamaha YPG-225 Main Circuit Board Replacement

Lonnie Bissmeyer 和 6 其他贡献者

最后更新于 March 19, 2020

15 - 25 分钟

中等

需要更好的图片

不正确的工具

简介

转到步骤 1

Learn to remove and replace the main circuit board in your Yamaha YPG-225 keyboard with this guide. The process is moderately involved and requires the removal of many screws and light force for some parts.

你所需要的

工具

当你通过这些链接购买商品时，iFixit 会赚取佣金。

步骤 1 Batteries

Yamaha YPG-225 Main Circuit Board Replacement, Batteries: 步骤 1 中的图像 1，1

Turn the keyboard over so that the keys are facing the ground.

翻译

步骤 2

Pop the tabs on the battery casing and remove it from the back plate.

翻译

步骤 3

Locate the six batteries and remove them from the battery cavity.

翻译

步骤 4 Faceplate

Yamaha YPG-225 Main Circuit Board Replacement, Faceplate: 步骤 4 中的图像 1，1

Remove the six 10mm screws at the top of the backplate.

翻译

步骤 5

Remove the seven 12mm screws in the middle of the back plate.

翻译

步骤 6

Remove the eight 10mm screws from the side and the bottom of the back plate.

翻译

步骤 7

As the face plate is no longer connected to the body of the keyboard, be careful to not drop the body when performing this step.
Flip over the keyboard.

翻译

步骤 8

Lifting from the front and the back of the face plate equally, pull the face plate up and then back, away from the keyboard.
Be careful when removing the face plate. There are wires attached.

翻译

步骤 9 Main Circuit Board

Yamaha YPG-225 Main Circuit Board Replacement, Main Circuit Board: 步骤 9 中的图像 1，1

Locate the main circuit board in the middle of the detached face plate.

翻译

步骤 10

Use a plastic opening tool or spudger to carefully pry up the beige ribbon connectors and remove the wires from them.
Be sure to use a tool that is ESD safe!
Use a slightly upward force as parallel to the ground as possible.
Be sure to make a mental note or jot down the locations of the specific ribbon cables. Some are in close proximity to each other and it can be easy to forget which ribbon goes where.
Be sure to unplug the smaller ribbon that connects to a different circuit board.
Take care not to use too much force. The connectors are fragile, the ribbon wires are easily bent, and too much force may damage the circuit board if you happen to miss.

翻译

步骤 11

Move the ribbons out of the way, and remove the eight 10mm screws in the middle that hold the circuit board down.
Remove the two 12mm screws in the corner of the circuit board.

翻译