Teenage Engineering OP-Z Expansion Module Replacement - iFixit 维修指南

加入维修社区 - 创建账户

简介

Use this guide to remove the expansion module in the OP-Z.

1. 步骤 1 Back Cover
  Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.
  
  There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.
  编辑
  
  询问修复机器人
  
  添加评论
  
  1024
2. 步骤 2
  When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).
  
  If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.
  编辑
  
  询问修复机器人
  
  添加评论
  
  1024
4. 步骤 3
  Remove the bottom plate including the rubber feet.
  编辑
  
  询问修复机器人
  
  添加评论
  
  1024
1. 步骤 4 Expansion Module
  Use your finger or a spudger to push up on the small tab on the bottom of the module.
  
  Lift the module up and out of its recess bottom first.
  编辑
  
  询问修复机器人
  
  添加评论
  
  1024
2. 步骤 5
  Remove the module.
  
  When inserting another module make sure you put it in outputs first. Then push down the bottom part for the tab to engage.
  编辑
  
  询问修复机器人
  
  添加评论
  
  1024

结论

To reassemble your device, follow these instructions in reverse order.

取消：我没有完成这个指南。

作者

与1其他贡献者

Tobias Isakeit

于03/31/14注册

134,495 声望

创作了189篇指南

+ 47更多徽章

团队

Tobias Isakeit - Repairability Engineer Tobias Isakeit - Repairability Engineer 的会员

Business

1 名成员

创作了1,251篇指南

0指南评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 10

过去 30 天： 37

总计 1,595