简介

If you have identified that your record player needs to have its motor replaced, this guide will show you how to safely do so. The motor is what controls the speed the record plays at, and may wear down or completely fail over time and with use. Replacement is easy if these steps are followed. Note that it is first important to complete the Disassembly Guide.

Remove the three brass screws using a phillips #1 screwdriver.
  • Remove the three brass screws using a phillips #1 screwdriver.

添加评论

Cut the wires that are attached to the motor.
  • Cut the wires that are attached to the motor.

  • Be sure to note the attachment point so that the wires can be reattached to the new motor.

添加评论

  • Using the phillips #1 screwdriver, remove the three screws that are holding the circular mounting bracket to the motor.

  • Remove the circular mounting bracket from the motor.

添加评论

  • Attach the mounting bracket to the new motor.

  • Insert the new motor.

  • Flip the turntable over making sure the motor stays in place, and insert the screws underneath the turntable.

添加评论

  • The ends of the wires will need to be stripped before soldering.

  • Be extremely careful not to burn yourself while soldering.

  • Solder the wires cut wires onto the motor in the location recorded previously.

添加评论

结论

To reassemble your device, follow these instructions in reverse order and complete the disassembly guide in reverse order.

Jake Hamilton

于2012年09月19日注册

134 信誉积分

创作了2篇指南

团队

Cal Poly, Team 2-61, Propen Fall 2012 Cal Poly, Team 2-61, Propen Fall 2012 的会员

CPSU-PROPEN-F12S2G61

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 9

总计 1,263