Skip to main content

介绍

Use for a diagnosed wiring problem.

配件

没有特定配件。

  1. Remove the backplate. Using a Torx T20 screwdriver, remove the four screws attaching the back plate.
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

  2. Remove the drill handle.
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

  3. Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物

    Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物
  4. Remove the gear casing from the body. Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.
    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

  5. Use a multimeter set above 18V DC to check electrical connections where wires meet drill, switch, or battery terminal.
    • Use a multimeter set above 18V DC to check electrical connections where wires meet drill, switch, or battery terminal.

  6. Look for corrosion or burnt wires.
    • Look for corrosion or burnt wires.

    • If there are any bad connections or if there is visible damage, replace damaged wire and solder.

    • After soldering sand off jaged solder then wrap with electrical tape

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Evan Long

于2010年04月15日注册

232 Reputation

创作了4篇指南

Team

Cal Poly, Team 15-48, Garner Spring 2010 Cal Poly, Team 15-48, Garner Spring 2010 的会员

CPSU-GARNER-S10S15G48

6 名成员

创作了5篇指南

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 23

All Time: 4,291