配件

无需配件。

Slide the back cover down with your thumb.
  • Slide the back cover down with your thumb.

  • *Note: the battery cover is not shown in this picture

添加评论

Gently lift the battery with a fingernail and remove it from its housing. *Note: the battery may be replaced or repaired at this step
  • Gently lift the battery with a fingernail and remove it from its housing.

  • *Note: the battery may be replaced or repaired at this step

添加评论

On some models, the front case is screwed down from the back.  Follow steps 5 and 6 FIRST to remove the camera cover and two T6 screws, before removing the faceplate. Use the Spudger to gently pry up the edges of the front face plate At the center of the faceplate edge below the music keys there is a small latch on each side.
  • On some models, the front case is screwed down from the back. Follow steps 5 and 6 FIRST to remove the camera cover and two T6 screws, before removing the faceplate.

  • Use the Spudger to gently pry up the edges of the front face plate

  • At the center of the faceplate edge below the music keys there is a small latch on each side.

Before doing this step, first remove the camera cover and the two t6 screws from the back (steps 5 and 6). Otherwise you will break the cover. This may be a factor only for some revisions (RM-304)

s c - 回复

Lift up the keypad from the bottom with either the spudger or your finger. Note: at this time the keypad can be removed and replaced
  • Lift up the keypad from the bottom with either the spudger or your finger.

  • Note: at this time the keypad can be removed and replaced

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

5等其他人完成本指南。

Max Kirby

于2011年05月01日注册

515 信誉积分

创作了8篇指南

团队

Cal Poly, Team 15-14, Regan Spring 2011 Cal Poly, Team 15-14, Regan Spring 2011 的会员

CPSU-REGAN-S11S15G14

3 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 4

过去的30天: 18

总计 5,316