简介

This guide explains how to replace the speaker in a first-generation Nintendo Game Boy system.

视频概述

Switch your Game Boy off and remove the cartridge.
  • Switch your Game Boy off and remove the cartridge.

添加评论

Use a fingernail (or small coin) to push down on the battery door latch and remove the battery door.
  • Use a fingernail (or small coin) to push down on the battery door latch and remove the battery door.

    • The release latch is a plastic spring clip. If your Game Boy is getting on in years, be careful as the plastic may be brittle.

    • When you're replacing the cover, be sure to get its two plastic tabs into the slots in the bottom of the battery compartment before pushing the cover back in place.

添加评论

  • Use a fingernail to pry each battery outward from the positive (+) terminal to remove them.

    • Dispose of used batteries properly!

    • Remove the batteries from your Game Boy before storing it for more than a month or so.

添加评论

  • Remove the six Triwing screws from the back of the device.

添加评论

  • Gently separate the device's front casing from the back casing after you remove the screws.

    • Be careful not to completely separate the casing halves, as they are still joined by a large ribbon cable that may be damaged.

添加评论

  • Slide the front side of the casing down to expose the ribbon cable connector.

添加评论

  • Grip the ribbon connector with your thumb and forefinger. Pull down gently until the connector, not the ribbon itself, comes out of its socket.

  • Separate the front and back casings.

添加评论

  • Remove the 10 Phillips #00 screws from the motherboard.

添加评论

  • Use a plastic opening tool to gently lift the motherboard up and remove it from the front plastic case.

  • Use caution when lifting the board since the speaker is attached.

添加评论

  • Desolder the two wires connecting the speaker to the motherboard.

  • Remove the speaker.

  • If you're new to soldering, refer to this guide for tips that will help with desoldering the speaker wires and/or soldering the new ones in place.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

Andrew Tramposch

于2010年06月24日注册

1,496 信誉积分

创作了11篇指南

团队

Cal Poly, Team 3-2, Johann Summer 2010 Cal Poly, Team 3-2, Johann Summer 2010 的会员

CPSU-JOHANN-R10S3G2

3 名成员

创作了11篇指南

This is just a guide to remove the speaker not replacing it so change the title as it is misleading as people that following this will want know how to replace not remove only

Paul - 回复

As stated in the conclusion, you simply follow the steps in reverse to install your replacement speaker.

Jeff Suovanen -

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 22

过去的30天: 108

总计 18,350