跳转到主内容

简介

This guide walks through how to remove and replace a display on the Dell Latitude E4310 laptop in the event of a broken or bad display.

  1. Power down the laptop and remove all power cords.
    • Power down the laptop and remove all power cords.

  2. Push in the battery release button with your thumb. Pull up on the battery to remove.
    • Push in the battery release button with your thumb.

    • Pull up on the battery to remove.

  3. Open  up the laptop and flatten it down on a workable surface. Turn it around so that the screen is closest to you. Insert the flat end of a spudger, or plastic opening tool, into the groove between the screen bezel and top case.
    • Open up the laptop and flatten it down on a workable surface.

    • Turn it around so that the screen is closest to you.

    • Insert the flat end of a spudger, or plastic opening tool, into the groove between the screen bezel and top case.

    • Twist the spudger, or plastic opening tool, until you hear a clicking sound and continue doing this around the entirety of the display.

    • Remove the bezel.

  4. Apple Watch 套装

    Screen and battery repairs just got easier.

    现在开始购物

    Apple Watch 套装

    Screen and battery repairs just got easier.

    现在开始购物
  5. Remove the six 0.3mm Phillips #1 screws. Remove the six 0.3mm Phillips #1 screws.
    • Remove the six 0.3mm Phillips #1 screws.

  6. Remove the two 0.5mm Phillips #1 screws. There are two screws located at each corner. Only remove the ones closest to the outer edge.
    • Remove the two 0.5mm Phillips #1 screws.

    • There are two screws located at each corner. Only remove the ones closest to the outer edge.

  7. Carefully lift the screen up and flip it over onto the keyboard side as if you were turning the page of a book. Carefully lift the screen up and flip it over onto the keyboard side as if you were turning the page of a book.
    • Carefully lift the screen up and flip it over onto the keyboard side as if you were turning the page of a book.

  8. Use a pair of tweezers to flip the blue tape 180 degrees. By flipping the tape you disconnect the display connector. By flipping the tape you disconnect the display connector.
    • Use a pair of tweezers to flip the blue tape 180 degrees.

    • By flipping the tape you disconnect the display connector.

  9. Remove the screen from the laptop.
    • Remove the screen from the laptop.

结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

Aylin

于2018年02月21日注册

234 信誉积分

撰写一个指南

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 5

过去的30天: 20

总计 415