简介

Removing the front cover gives access to lens housing, and allows removal of the top cover.

配件

无需配件。

  1. Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.
    • Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.

    添加评论

  2. Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.
    • Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.

    添加评论

    • Remove the battery from inside the battery housing and set the cover aside.

    添加评论

    • Remove the two 6.4mm screws above the lens aperture using a phillips #00 screw driver.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the 6.4mm screw from the inside of the flash bezel.

    添加评论

    • Flip the camera upside down and remove the 5.4mm screw below the lens bezel on the front of the camera.

    添加评论

    • Remove the 5.6mm screws behind the battery cover.

    添加评论

    • Remove two 6.4mm screws on the latch mechanism on the right side of the camera.

    添加评论

    • Remove the 6.4mm screw on the top of the inside edge of the battery hole.

    添加评论

    • Starting at the flash, carefully pull the front cover away from the camera.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Mark

于2011年04月20日注册

93 信誉积分

创作了5篇指南

团队

Cal Poly, Team 8-9, Regan Spring 2011 Cal Poly, Team 8-9, Regan Spring 2011 的会员

CPSU-REGAN-S11S8G9

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 2,082