修复你的物品 社区 商店

Briggs and Stratton 675 Series Repair Muffler Replacement

简介

Follow these steps to remove the muffler from your Briggs and Stratton 675 engine. Once removed, a damaged muffler can be replaced or a dirty one cleaned. The muffler can become dirty or damaged over time. It is important to keep it clear of debris so that the exhaust coming from the engine can flow normally.

你所需要的

  1. Briggs and Stratton 675 Series Repair Muffler Replacement, Muffler: 步骤 1 中的图像 1，1

    • Make sure the engine is off and the spark plug wire is removed and away from the spark plug before beginning.

    • Use a socket wrench with a 1/4" hex bit or a 1/4" wrench to remove the three 13mm screws holding the outer flange.

    • Remove the flange.

    翻译

  2. Briggs and Stratton 675 Series Repair Muffler Replacement: 步骤 2 中的图像 1，1

    • Use a pair of needle nose pliers to bend back the two metal tabs on either side of the remaining screws.

    • Be careful not to break off the tabs.

    翻译

  4. Briggs and Stratton 675 Series Repair Muffler Replacement: 步骤 3 中的图像 1，1

    • Use a socket wrench with a 7/16" hex bit or 7/16" wrench to remove the two remaining 75mm screws.

    • Make sure not to lose the metal bar linking the two screws.

    翻译

  5. Briggs and Stratton 675 Series Repair Muffler Replacement: 步骤 4 中的图像 1，2 Briggs and Stratton 675 Series Repair Muffler Replacement: 步骤 4 中的图像 2，2

    • Remove the muffler from the engine block by simply pulling it away.

    • After removing the muffler, make sure to note the configuration of the washer assembly that sits between the muffler and the engine block (shown in photo 2). This piece will be free to fall out once the muffler is removed. Do not lose this piece.

    翻译
结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

作者

与6其他贡献者

Brad Wash

于02/02/15注册

476 声望

创作了2篇指南

徽章: 15

+ 12更多徽章

团队

Cal Poly, Team 6-31, Amido Winter 2015 Cal Poly, Team 6-31, Amido Winter 2015 的会员

CPSU-AMIDO-W15S6G31

4 名成员

创作了14篇指南

一条评论

When I removed the muffler from the engine block by simply pulling it away, the thermic regulator fell out and I don't see how/where to fix it again.

Thanks for any help !!!

yvessr - 回复

添加评论

浏览统计数据:

过去 24 小时： 5

过去 7 天： 51

过去 30 天： 173

总计 13,167