跳转到主内容

简介

If the difficulty button on an Atari Flashback 2 console is sticking or broken, then it will need to be cleaned or replaced. This guide covers the steps necessary to disassemble the console in order to access the buttons for replacement.

配件

没有特定配件。

  1. Using the screwdriver and the PH1 bit, unscrew the five 10.0 mm screws on the bottom of the console. One screw is under the main sticker in the middle of the console. One screw is under the main sticker in the middle of the console.
    • Using the screwdriver and the PH1 bit, unscrew the five 10.0 mm screws on the bottom of the console.

    • One screw is under the main sticker in the middle of the console.

  2. iPhone 电池维修工具包

    只要 $29.99

    Buy Now

    iPhone 电池维修工具包

    只要 $29.99

    Buy Now
  3. Unscrew the two 10.0 mm Phillips #1 screws, and gently pull back the green circuit board. Remove gently. The circuit board is connected by wire to the board. Removing the cable from the console case may allow more slack.
    • Unscrew the two 10.0 mm Phillips #1 screws, and gently pull back the green circuit board.

    • Remove gently. The circuit board is connected by wire to the board. Removing the cable from the console case may allow more slack.

    • The button springs may be under compression.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Aaron Ramadan

于2018年09月17日注册

135 信誉积分

撰写一个指南

团队

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 7

总计 58