My daughter dropped her Atrix (first release) in the sink full of water. She pulled it out and let it dry. Then she did something dumb she plugged the charger into it!? I do a lot of repairs on various electronics Voicemail systems,PBX systems and key telephone sets. I am somewhat savy wih electronics. I do solder but not on the micro level. Is there any hope for this phone?
thanks
Joe Deaton
joe@ae-comm.net
声誉积分: 783千
1.1千
893
2.3千
Joe Deaton, the first thing that I would do is to disassemble the phone and clean it using [http://ttp://www.ifixit.com/Wiki/Electronics_Water_Damage|this as a ] general guide. Check your logic board for anything "suspicious" replace the battery and see what you really got. Luckily, most of the damage may be confined to the smart battery or the charging circuit. Here is the teardown of the Atrix that should help you to see what is involved. Hope this helps, good luck.
这个答案有帮助吗？
过去 24 小时： 0
过去 7 天： 5
过去 30 天： 6
总计 2,183
1条评论
I did the same thing, I replaced every part but the mainboard and never got it working again. It's dead, jim.
由 Brett 完成的