I have a Whirlpool (Model # WDF520PADM7) I bought about a couple years ago. When you select any cycle and push start, the dishwasher fills with water and heats up. It will not run. It seems to go through the cycle because the detergent door will open and after the correct amount of time, the clean light comes on, but the dishes are still dirty. I checked the door switch and it is operating fine. Any suggestions?
声誉积分: 685.3千
3.4千
1.1千
2.6千
The circulation pump uses a motor and impeller to force water up through the wash arms. If the circulation pump is defective, the dishes won’t be cleaned properly. If the motor isn’t making any noise or is just making a humming sound after the dishwasher has filled, the motor may be burned out. First, ensure that power is getting to the motor. Second, to ensure that the impeller can turn, check the pump housing for debris. If power is getting to the motor and the pump is clear of debris, the motor might need to be replaced. Be aware that the circulation pump may be challenging to replace, although many do-it-yourselfers have been successful with the replacement.
Here’s the part:
这个答案有帮助吗？
过去 24 小时： 0
过去 7 天： 3
过去 30 天： 16
总计 177
