I am trying to find this connector thats on the board but I cannot figure out who manufacturers it or a part number. It is the I/O Board to Board connector on the main motherboard and the original I am trying to replace was damaged. Anyone know what it is or where I can get one preferably new.
Board to board connector I am trying to identify and replace
声誉积分: 221.5千
15
290
807
Board connectors can be very difficult to source...in some cases they are only available in bulk directly to manufacturers. While I don;t know where this one can be found I'll make a few suggestions which may help out, if not you then others who will invariably find this question in the future.
Good luck with your search. If you find one, make sure to report back for the benefit of others. Maybe someone else like @mayer, @reecee or @tcrs_circuit who specialize in Mac's will have better info.
这个答案有帮助吗？
Nick your logic board is a 820-3787 and the connector in question is J9510 Board-to-Board Flex connector. It is listed as a 20590-032E-25
Thanks @oldturkey03, I hadn't gotten around to that part yet :>).
@refectio anytime Sir, anytime ;>)
声誉积分: 3.5千
6
7
2
Your going to have to pull it from a donor board. Use lots of flux, and heat the donor board from the bottom from directly below the connector. You will need a beefy hot air station like the Quick 861DW. To solder it, your going to put some leaded solder on the pads, wick it away, add new solder and flux, place the connector then bottom heat again on the patient board.
There is nothing easy about this. It is a real pain
这个答案有帮助吗？
过去 24 小时： 0
过去 7 天： 6
过去 30 天： 17
总计 265
