跳转到主内容

A washer series by Maytag with a low rate of customer satisfaction and a high rate of failure.

157 个问题 查看全部

OL code all the time even with very small and light load

Every time I wash the clothes it fills and then just drains and shuts off with code OL So it means over load but I am a single guy with maybe 1 towel and socks and underware hardly a big load so why is it happening??

回答此问题 我也有这个问题

这是一个好问题吗?

按维修分数 2

评论:

I need the answer, too. I have to put the washer on the cycle “drain and spin.” Only then will I get clothes dry enough to put in the dryer.

添加一条评论

Macbook 电池维修套装

起价 $69.99

Buy Now

Macbook 电池维修套装

起价 $69.99

Buy Now

1个答案

最有帮助的答案

@mudslide3

Donald Booth OL stands for “Overload”. The washer thinks the tub is too hard to move because it’s overloaded and the motor is struggling or the unit is way out of balance causing the washer to struggle. The most common problem is a nut below the inner tub that needs to “float”. Floating is when the tub fills up with water to a certain level the inner basket will rise about 1 inch from the center agitator. What this does is disengage the basket from the motor so that the agitator can rotate independently from the basket. If the basket does not float then when it tries to agitate the whole basket will turn back and forth at the same speed as the agitator and this will cause the OL error code. Of course it is also possible that the inner tub may be jammed in the down position, unable to float off the drive hub because of a rusted drive shaft or just some socks (remember that all washers seem to be eating socks etc.;-) or something else, lodged in between the inner and outer baskets causing the same result. We really would need the exact washer model number for further information.

这个答案有帮助吗?

按维修分数 1
添加一条评论

添加你的答案

walter wisting 将永远感激不已
浏览统计数据:

过去的24小时: 6

过去的7天: 28

过去的30天: 118

总计 1,386