iPhone 5s logic board EMI SHIELD

Question

iPhone 5s

苹果 iPhone 5s 于2013年9月10日公布。该设备的维修与以前的型号相似，需要螺丝刀和撬棒。可使用GSM或CDMA / 16、32或64 GB。颜色有银色、金色和太空灰。

3530 个问题查看全部

John Smith @johnsmith57855

声誉积分: 47

4

1

发帖于: 2015年7月30日

更多选项

iPhone 5s logic board EMI SHIELD

Hello Everyone...

I cant connect my iPhone to my computer and problem is with USB control IC chip and I was wondering that if it is possible to solder the EMI Shield back into place with a heat gun after removing it .

Please someone help

Thank you

已回答！ 显示答案我也有这个问题

这是一个好问题吗？

是否

得分 2

添加一条评论

1个答案

已选择的解决方案

oldturkey03 @oldturkey03

声誉积分: 782.4千

1.1千

893

2.3千

发帖于: 2015年7月30日

更多选项

John Smith, I am not quite following you with this. Yes you can resolder the EMI shield, but use a soldering iron versus a hot air gun. You will have better control over the heat than you would with a hot air gun. My confusion is with the shield and the connection of the USB control IC....Any problem with that IC will not be related to the EMI shields

这个答案有帮助吗？

是否

得分 2

4条评论:

Thank you for the quick response. Your right but i have to remove the EMI shield to get to the USB control IC which is located near the processor.

Can you please tell how to resolder it back into place

And thank you again for responding

由 John Smith 完成的 2015年7月30日

Depends on how you took the shields off. If you used a hot air station to remove it, you should be able to resolder it at the same solder points. If you did not and you cut it off or removed it by other means, you could try to mate some points or leave the shield of altogether.

由 oldturkey03 完成的 2015年7月30日

Thanks for your help i've got my answer

由 John Smith 完成的 2015年7月30日

John Smith, how did you get the EMI shield back on? Oldturkey will leaving the EMI shield off altogether affect how the phone works?

由 William Camp 完成的 2016年3月11日

添加一条评论

Thank you for the quick response. Your right but i have to remove the EMI shield to get to the USB control IC which is located near the processor.

Can you please tell how to resolder it back into place

And thank you again for responding — John Smith
Depends on how you took the shields off. If you used a hot air station to remove it, you should be able to resolder it at the same solder points. If you did not and you cut it off or removed it by other means, you could try to mate some points or leave the shield of altogether. — oldturkey03
John Smith, how did you get the EMI shield back on? Oldturkey will leaving the EMI shield off altogether affect how the phone works? — William Camp

iPhone 5s

iPhone 5s logic board EMI SHIELD

1个答案

添加你的答案