I plugged my 110v hand blender in a 220v power source. It made a flash, and never turned on again, so we can assume its burned, right?
What exactly was damaged?
Is it possible to fix it?
How?
Where do I buy the parts needed to do it?
声誉积分: 784.3千
1.1千
894
2.3千
pedro, the only way to determine exactly what has overloaded is by taking the blender apart. Most likely it is the caps (potentially a fuse on a circuit board) or even the motor. But, you'll have to take it apart to see what needs to be replaced.
这个答案有帮助吗？
Hi oldturkey!
Thank you for your message!
So do you think I should take it apart? I am not very experienced in doing stuff like that, but, on the other hand, I don't think I have another choice...
I will open it and post the photos soon!
I definitely would take it apart. Take lots of pictures so you know what goes where. then take a couple of hi-res images of the electronic components and post those to keep us informed.
hi dude, i did the same. could u pl tell what happened to the motor and how to solve the issue
过去 24 小时： 0
过去 7 天： 3
过去 30 天： 7
总计 1,144
1条评论
hi dude, i did the same. could u pl tell what happened to the motor and how to solve the issue
由 sunil gupta 完成的