Broken Wii U Gamepad ribbon CLIP during screen replacement!

Question

Nintendo Wii U GamePad

This is a touch-screen controller associated with the Wii U video game console. It was released on November 18th, 2012, and available in black or white. Model number: WUP-010(USA)

83 个问题查看全部

xojoeox @xojoeox

声誉积分: 49

3

1

发帖于: 2014年9月29日

更多选项

Broken Wii U Gamepad ribbon CLIP during screen replacement!

Hello,

I recently broke my Wii U gamepad screen (the digitizer is working just fine)

so I ordered a replacement screen online

the screen have 3 ribbon cables , 2 from the top (screen and digtizer)

and one small ribbon cable on the side , I broke the clip the keeps the ribbon cable in contact with the pins

The game pad is working (I can still play) , but the screen will not power up

is there a way to replace the clip , or any solution to keep the ribbon cable in contact with the pins ?

or do I need to replace the entire gamepad !?

回答此问题我也有这个问题

这是一个好问题吗？

是否

得分 4

添加一条评论

4个答案

Tech @tech65348 声誉积分: 115 3 · Answer 1 · 2014-10-08T19:20:16-07:00

OK, this all depends on how skilled you are:

Easy Method:

1. Insert the ribbon back into the slot.

2. Take the broken part of the clip and lay it back down right on top of the pins. If you don't have the black switch then simply use something like a very small flat head screw driver or a needle instead.

3. Put a bit of pressure on the pins then lay a good sized piece of black tape or even glue gun glue on the area.

Skilled Method:

1. Remove any covering on the connector area revealing the bare pins.

2. Either you lay the ribbon on top of the bare pins and glue gun or black tape the ribbon to the pins while asserting pressure, OR use thin wire and soldier the pins to the corresponding contacts on the ribbon, then clean everything up with glue gun or black tape. Make sure the wires don't touch each other.

Either way, the ZIF connector that you broke is the one to the backlight for the LCD of the Gamepad. Basically this component gives the screen light. This repair could be done the same way to any ZIF connector so if you break the digitizer one next, you can fix it the same way.

Take your time next time, your welcome!