当前版本： radu_cloud

文本:

状态:

open

编辑： Kristen Gismondi （投票详情）

文本:

Hi, I’ve found that going into the so-called “low frequency mode” fixes it completely - after also having made a firmware update (so my firmware is now as of 1-aug-2020).

For those unaware, “low frequency mode” does not put in a low frequency booster, as it might sound, but instead disables the sound processor. The same sound processor that cuts out quiet sounds also cuts low frequencies at high amplitudes, to avoid distortion - therefore they call this disabling “low frequency mode” because there will be no more low frequency CUTTING. So, thank you JBL, but I like my sound just as it is; if it’s so loud that it distorts, I can take care to lower the volume or put in an equalizer as I desire.

So:

bluetooth + volume minus - go into “low frequency mode” a k a unaltered sound

play/pause + volume plus - hardware reset, to go back - of course, all other settings are lost too

状态:

编辑： radu_cloud

文本:

Hi, I’ve found that going into the so-called “low frequency mode” fixes it completely - after also having made a firmware update (so my firmware is now as of 1-aug-2020).

For those unaware, “low frequency mode” does not put in a low frequency booster, as it might sound, but instead disables the sound processor. The same sound processor that cuts out quiet sounds also cuts low frequencies at high amplitudes, to avoid distortion - therefore they call this disabling “low frequency mode” because there will be no more low frequency CUTTING. So, thank you JBL, but I like my sound just as it is; if it’s so loud that it distorts, I can take care to lower the volume or put in an equalizer as I desire.

So:

bluetooth + volume minus - go into “low frequency mode” a k a unaltered sound

play/pause + volume plus - hardware reset, to go back - of course, all other settings are lost too

状态:

编辑： radu_cloud

文本:

状态:

open

编辑： radu_cloud

文本:

状态:

open

编辑： radu_cloud

文本:

状态:

open

原帖由： radu_cloud

文本:

Hi, I found that going into the so-called “low frequency mode” fixes it completely - after also having made a firmware update (so my firmware is now as of 1-aug-2020).

For those unaware, “low frequency mode” does not put in a low frequency booster, as it might sound, but instead disables the sound processor. The same sound processor that cuts out quiet sounds also cuts low frequencies at high amplitudes, to avoid distortion - therefore they call this disabling “low frequency mode” because there will be no more low frequency CUTTING. So, thank you JBL, but I like my sound just as it is; if it’s so loud that it distorts, I can take care to lower the volume or put in an equalizer as I desire.

So:

bluetooth + volume minus - go into “low frequency mode”

play/pause + volume up - hardware reset, to go back - of course, all other settings are lost too

状态:

open