joe

@j0vian

joe

2,678	信誉积分
168	解决方案
1	指南
于2013年12月31日注册

团队

Trex Computers

Computer Repair Service for Mac or Pcs, Laptops or...

投票

I am a pc, mac, laptop, desktop technician with over 20 years experience.

我的指南

How to build a Mailbox out of an old Apple G5 Mac Pro tower

我曾参与过编写的指南

MacBook Pro 13" Unibody Mid 2010 Keyboard Replacement

我帮助翻译的指南

HP 550 Notebook LCD Display Replacement

我最爱的指南

Constructing a Capacitor Discharge Tool

How to Safely Discharge a Capacitor

已完成的指南

iPhone 6 Plus 屏幕组件更换维修指南

Xbox One 电源适配器 (首发限定版) 拆解

Samsung Galaxy Tab Pro 12.2 Battery Replacement

iMac Intel 21.5" EMC 2544 Display Replacement

Galaxy Tab S 10.5 Battery Replacement

SwagTron T1 Gyroscope Replacement

How to build a Mailbox out of an old Apple G5 Mac Pro tower

SodaStream Source Internal Carbonation Air Hose Replacement

Nutri Ninja Ninja Blender Duo BL641 Power Cord Replacement

iPad Air WIFI版前面板替换

1 / 2 页

How to I get data off of this damaged iPod. 2018年01月05日
I have 2 damaged ipods that a customer has requested for me to retrieve her songs. I have tried many options and I cannot get...

问题解答论坛

回复： Where can I find a screw chart? 2018年01月11日
heres a screw mat here thats all i can find...
回复： controler does not work! 2018年01月11日
charge the controller or put in fresh batteries, unplug the xbox, wait 30 seconds, plug it back in then test it by turning on the console then turn on the controller.
回复： screen out of adjustment 2018年01月11日
Before you all go fiddling with complicated calibration settings, try this simple solution with an old toothbrush: Use a card or fingernail to slightly lift the screen bezel around the touch screen, only needs to be just enough to get a few toothbrush bristles under it. Work the brush bristles gradually right around the screen and note what drops out on a clean sheet of paper. A few grains of sand / grit is enough to screw up your screen sensitivity. Better yet, blast air under the bezel as you lift it. Use a can of air (as used for cleaning photographic lenses) with a fine nozzle attached. if this does not work this is a link to a document which shows how to calibrate the tomtom screen for a certain model. English: http://www.martin-kolinsky.com/freeinstructionsfordownload...-Touch%20screen%20calibration.pdf and if this does not work... First create a backup of your gps with windows explorer using the procedures in this link.This is important in protecting your map data which if you lose you may have to purc...
回复： Ring video doorbell will not connect to wifi 2018年01月11日
How do you reset the ring doorbell? If the light still doesn't start spinning when you push the orange button, try performing a hard reset. To perform a hard reset, hold down the black button for 15 seconds. After releasing it, the light on the front will flash a few times indicating that your Ring Doorbell is restarting then re start the setup process all over again. Ring setup video
回复： SSD drive rebooting, reinstall OS X 2018年01月11日
If you cannot see the drive then you cannot format the drive. You should run diagnostics by holding down d during startup. Most likely you have a failed ssd and it will most likely need to be replaced.
回复： Sourcing a Built in Keyboard for MacBook Pro 2012 2018年01月11日
I have had good luck with most of the keyboards on amazon. I have received a dud or two but for the most part I have gotten good quality parts. I haven't had any keyboards fail after installing them I just got a couple one time that had sticking keys. Just make sure you use amazon prime so it makes it easier to return if necessary.
回复： Blinking question mark folder. Command Option R doesn't work. 2018年01月11日
Hold during startup Shift (⇧) Start up in safe mode. Option (⌥) Start up to Startup Manager, which allows you to choose other startup disks, if available. If your Mac is using a firmware password, you're asked to enter the password first. D Start up from the built-in Apple Hardware Test or Apple Diagnostics utility, depending on your Mac model. Or use Option-D to start up from this utility over the Internet. N Start up from a compatible NetBoot server, if available. To use the default boot image on the NetBoot server, hold down Option-N instead. iMac Pro doesn't support this startup key. Command-R Start up from the built-in macOS Recovery system. Or use Option-Command-R or Shift- Option-Command-R to start up from macOS Recovery over the Internet. macOS Recovery installs different versions of macOS, depending on the key combination you use while starting up. Option-Command (⌘)-P-R Reset NVRAM (or PRAM). If your Mac is using a firmware password, this combination causes your Mac to start up from macOS Recovery i...
回复： flashing number error c4eba341 2018年01月10日
unplug printer power cord from back of printer, hold down power button for 10 seconds. Plug printer back in . power up printer
回复： Why are the back lights on permanently? 2018年01月10日
The backlight is what actually brightens or dims the entire television display, so if it’s a bit too bright for your liking, just turn it down a bit. And if it’s not bright enough, crank it up to a level that’s suitable. However, make sure to leave the “brightness” alone unless you’re re-calibrating your TV’s picture. For day-to-day adjustments, backlight is what you want.
回复： Can send to wireless printer 2018年01月10日
Delete the printer and reinstall the printer drivers. Download updated drivers by entering the model number on the manufacturers website.

1 / 17 页

信誉积分分解

活动	计算	Delta
帖子被投票赞成	156	1700
答案被采纳	25	750
管理员通过了你的指南	1	240
你翻译了一本指南	1	7
已接受巡查指南步骤编辑	1	1
已接受巡查指南编辑	1	1
对一个帖子投反对票	2	-4
帖子被投票否决	3	-18